The PEEK fan is connected to Heat 1 - it's configured to come on when the hot end is at 60C or higher.g.
Strange behaviour while platform descending to printbed
Re: Strange behaviour while platform descending to printbed
No, it has you connecting the layer fan to Fan 0. The PEEK fan is connected to Heat 1 - it's configured to come on when the hot end is at 60C or higher.
g.
The PEEK fan is connected to Heat 1 - it's configured to come on when the hot end is at 60C or higher.g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
-
DeltaCon
- Printmaster!
- Posts: 616
- Joined: Sat Nov 14, 2015 5:01 am
- Location: Wessem, The Netherlands
- Contact:
Re: Strange behaviour while platform descending to printbed
Oops, turned them around again...
Now you know why it never works for me the first time...
Now you know why it never works for me the first time...
I am DeltaCon, I have a delta, my name is Con, I am definitely PRO delta! 
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
-
christspringer271
- Plasticator
- Posts: 6
- Joined: Thu May 19, 2016 2:44 pm
- Contact:
Re: Strange behaviour while platform descending to printbed
I have same issue here! I am trying to search for all solutions from internet. 
-
DeltaCon
- Printmaster!
- Posts: 616
- Joined: Sat Nov 14, 2015 5:01 am
- Location: Wessem, The Netherlands
- Contact:
Re: Strange behaviour while platform descending to printbed
You mean the stopping of (one of) the skates while moving? Read back this thread, the solutions is above, and related to your (electrical) current settings.
I am DeltaCon, I have a delta, my name is Con, I am definitely PRO delta!
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
Rostock V2 / E3D Volcano / FSR kit / Duet 0.6
PS.: Sorry for the avatar, that's my other hobby!
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Strange behaviour while platform descending to printbed
DeltaCon, thanks for bringing the solution to our attention. That is a very good tip for others running that version of Repetier and I have not seen it documented any where else.
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”