I added and aluminum spreader to my bed, and so now it takes much longer to heat the bed. often times when i set the bed to 90c or more, it shuts off the heating before it even gets 75% there.
Where in the firmware can i extend this timer? I've been looking through the files in arduino but I haven found anything concrete and just want to make sure I'm adjusting the correct value. Thanks!!!
Looking to extend the shut off timer past 20 minutes
-
shentheory
- Printmaster!
- Posts: 58
- Joined: Wed Oct 22, 2014 11:54 am
-
Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7159
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Looking to extend the shut off timer past 20 minutes
Bumping message, any firmware experts to answer this question?
“ Do Not Regret Growing Older. It is a Privilege Denied to Many. ”
-
Tincho85
- Printmaster!
- Posts: 659
- Joined: Sun Nov 03, 2013 12:27 pm
- Location: Buenos Aires, Argentina
Re: Looking to extend the shut off timer past 20 minutes
No expert here 
, but you can change it though the EEPROM.
Fourth value:
Max Inactive Time
Mine is set to 1800000 ms (30 minutes)
, but you can change it though the EEPROM. Fourth value:
Max Inactive Time
Mine is set to 1800000 ms (30 minutes)
Martín S.