my z is slightly off what to adjust here

[mhackney]

Cambo3D, sorry - I was moving your topic from the "what are you printing" topic to this troubleshooting topic where it belongs. Unfortunately, it got irretrievably deleted - that was not the intent, I simply wanted to move it to the correct area.

Please repost.

[cambo3d]

dang you micheal..=P

[mhackney]

Yeah, sorry about that.

[mhackney]

Is it possible that one end lifted from the build surface during the print? Hard to tell from the photo and I forgot the details of your original post's description

[cambo3d]

Is it possible that one end lifted from the build surface during the print? Hard to tell from the photo and I forgot the details of your original post's description

it does look like the left side lifted but that was caused by me in the post process of cleaning up the skirt grid left behind. I started overdoing it by cutting away to much. It seemed the skirt stuck to well to the part.