Page 2 of 2
Re: Strange behaviour while platform descending to printbed
Posted: Thu May 19, 2016 9:28 am
by geneb
No, it has you connecting the layer fan to Fan 0.
The PEEK fan is connected to Heat 1 - it's configured to come on when the hot end is at 60C or higher.
g.
Re: Strange behaviour while platform descending to printbed
Posted: Thu May 19, 2016 12:52 pm
by DeltaCon
Oops, turned them around again...
Now you know why it never works for me the first time...
Re: Strange behaviour while platform descending to printbed
Posted: Wed Jun 01, 2016 12:38 pm
by christspringer271
I have same issue here! I am trying to search for all solutions from internet.
Re: Strange behaviour while platform descending to printbed
Posted: Thu Jun 02, 2016 7:17 am
by DeltaCon
You mean the stopping of (one of) the skates while moving? Read back this thread, the solutions is above, and related to your (electrical) current settings.
Re: Strange behaviour while platform descending to printbed
Posted: Fri Jun 03, 2016 1:10 pm
by Eaglezsoar
DeltaCon, thanks for bringing the solution to our attention. That is a very good tip for others running that version of Repetier and I have not seen it documented any where else.