Page 2 of 2
Re: ARM Board? Yes please!
Posted: Tue Oct 08, 2013 3:48 pm
by 626Pilot
Repetier automatically backs off the print speed if the buffer gets below a predefined constant (I think it's 11 or something) so with an SD card it would probably be fine. However, higher resolution = more stepping. At some point the processor will not be able to keep up.
Re: ARM Board? Yes please!
Posted: Tue Oct 08, 2013 4:26 pm
by cope413
So how many of you have stepped up and joined the KS fun?
Re: ARM Board? Yes please!
Posted: Wed Oct 09, 2013 2:21 am
by Flateric
KS = Kisslicer?
Re: ARM Board? Yes please!
Posted: Wed Oct 09, 2013 9:50 am
by cope413
KS = kickstarter. The smoothieboard
Re: ARM Board? Yes please!
Posted: Wed Oct 09, 2013 8:46 pm
by cope413
I'm guessing this has been posted somewhere, but i stumbled across it and figured it couldn't hurt to repost it.
Probably not the right thread, but it'll be relevant when the new firmware for ARM boards hits and people need to recalibrate...
Re: ARM Board? Yes please!
Posted: Sun Oct 13, 2013 7:28 am
by Flateric
cope413 wrote:KS = kickstarter. The smoothieboard
I'm in that one too, LOL.
Re: ARM Board? Yes please!
Posted: Fri Oct 18, 2013 12:26 am
by 626Pilot
Missed the window by a few days, they aren't taking dollars anymore... but I'm going to pick one up when they are in production.