Welcome to the SeeMeCNC Community

I attempted this print with a 15% infill! and it too looked great. This time, I actually had a little issue at the. Bottom, but I am fairly confident that it was a coling issue, as imam still not running with a layer fan on PLA.

Took lots of plastic just to figure out it isn't an issue after all, yet still a good thing to know.. No complaints here.

Topic is officially dead.

Thanks!

neurascenic wrote:I attempted this print with a 15% infill! and it too looked great. This time, I actually had a little issue at the. Bottom, but I am fairly confident that it was a coling issue, as imam still not running with a layer fan on PLA.

Took lots of plastic just to figure out it isn't an issue after all, yet still a good thing to know.. No complaints here.

Topic is officially dead.

Thanks!

that heated build chamber is looking better all the time.....

I'm Working on one, though it seems queer to me that I need to cool and heat at the same time.

Anybody know what the theory is? Each makes sense individually, just wondering about the combination.

HA!! and top that with cool only what needs to be cooled, and heat what only needs to be hot...