Welcome to the SeeMeCNC Community

How long is the bowden on the Orion ? Is it much shorter than a top loaded Max ?

I'm hoping that one of us "Air-Struder" guys stumbles upon a sample. If long bowden tubes are problematic with this material it probably could work with a short 2? or 3" tube...

I'll check that, I'll find a way to lower my extruder and try again with a shorter bowden... there is no way I would give up on my filaflex spool !!

Hi
i am new here
i have been printing with NinjaFlex since 3 days my printer is the Orion no mods
im printing with 10 mm speed and 230C
the last print is still running for 14 hours all the layers looks very good (still about 8 hours left)
but the main issue is the oozing it is something i could not stop

mrbdrm wrote:Hi
i am new here
i have been printing with NinjaFlex since 3 days my printer is the Orion no mods
im printing with 10 mm speed and 230C
the last print is still running for 14 hours all the layers looks very good (still about 8 hours left)
but the main issue is the oozing it is something i could not stop

Try turning the temperature down to 225.

Filaflex will expend a lot while heating up. They had many clogging issues while trying to achieve the 1.75mm Filaflex.
That is why, the filaflex filament is roughly 1.5mm, instead of 1.75mm.
To me, it only makes it more flexible and difficult to drive through a bowden tube.

What is Ninjaflex diameter ?