Have a look around and join today!
https://download.seemecnc.com/
Thanks for letting us know what JJ had to say.barry99705 wrote:Sent an email. JJ said he's never seen it happen before either. Neither of us thinks it's too serious, but if it starts to get worse, or starts degrading prints, they'll replace them.
Neptune wrote:if you use Simplify 3D you could use the "Start At" function, haven't tried it myself so don't know the particulars, just know the option is there.
just for the future, something I started doing is weighing my spools when they are full and anything over 1Kilo I deem "Spool Weight" then before I start a big print I weigh the remaining spool of filament and make sure I have the estimated amount to be used on the spool. Since I started doing that I haven't run out on a print.
Good luck.