Page 3 of 3
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Sat Feb 20, 2016 10:13 am
by Ail
The video is wrong if I am remembering correctly. Check the comments on the video to be sure.
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Sat Feb 20, 2016 12:04 pm
by geneb
omnibus wrote:Hey builders!
So far the manual has been great!
Question on the EZStruder, picture 10.3-1 on page 96 of the user manual (4.31 released feb 17 2016) seems to be assembled opposite to what is shown the in the checkpoint video. Which one is right? Does it matter?
-Omnibus
The photo only illustrates the wiring path. I should blur the rest out.
g.
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Sat Feb 20, 2016 12:10 pm
by geneb
Ail wrote:The video is wrong if I am remembering correctly. Check the comments on the video to be sure.
No, the video is not wrong.
g.
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Wed Aug 24, 2016 6:02 pm
by TimMcBrayer
I've just completed the build of my Rostock v2. I have to say that the instructions, in general were excellent. There were a few botched image references in the text, but nothing that couldn't be figured out easily.
The one major departure was the cold end instructions. Basically, much of Chapter 10 is incorrect/obsolete. The instructions are for the EZStruder; my kit came with a EZRStruder. True to the name, the build was ultimately easier than that in the documentation, but I had to figure it out myself. Hooray for this forum, where I found a discussion of the EZRStruder and used it to figure out the install without any instructions.
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Thu Aug 25, 2016 10:10 am
by geneb
Tim, if it's any consolation the inclusion of the EZRStruder is news to me.
I thought it was going to be a v3-only upgrade. *sigh*
g.
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Sun Jun 30, 2024 2:21 pm
by carter
PDF links are broken and oddly, website does not host any V2 docs.
A new link would be appreciated.
My immeadate need is to set up Orca and I was hoping the Users guide would have some basic machine stats. I don't recall a user guide existing 10 years ago.
Since there are many iterations of V2 this may be impossible to determine, but I am also trying to determine how large my nozzles are. I have 3 and since my slicer settings say 0.5, I know what is installed in the printer, but I also have a baggie with 2 nozzles that are unlabled. does the newer assembly guide list nozzles in inventory?
Re: [04Feb16 - Rostock MAX v2, 4th Edition Manual
Posted: Sun Jun 30, 2024 4:44 pm
by geneb
The docs for all the older stuff can be found here:
https://www.seemecnc.com/pages/downloads.
Scroll down about half-way to see the v2 & v1 documentation links.
g.