Page 3 of 3
Re: EZ Struder Upgrade - Need help testing and refining.
Posted: Tue Feb 23, 2016 4:45 pm
by miglo
Printed this 3x, I think it's pretty close to the size...maybr off .3mm? Either way the lever doesn't seem to push strongly enough against the filament. I may have to shave it down as well like the above user said.
Re: EZ Struder Upgrade - Need help testing and refining.
Posted: Sat Apr 15, 2017 8:29 pm
by wolfmann
I printed it it worked great until my extruder gear got ate up, (not because of this but because of use) . I want to try out the E3d hobb-gobblin but Its a little smaller is there anyone who has tried it with that gear?