Welcome to the SeeMeCNC Community

Hello,

So I built an enclosure for the printers and installed a heat lamp.

I want to control the lamp with SSR, do you know where I buy some SSR's with 12V control and 220V load?

also I would like to assign a new output pin from the rambo to control the SSR is that possible?

thanks a lot.

That's a pretty standard SSR, actually. Finding one for DC output is much trickier.

I've used these before. It's a nicer heatsink than most. https://www.inventables.com/technologie ... tate-relay

thanks
I order 5 of the for all my printers.

any info on how to connect it to a free pin on the rambo board?