Effector Platform in Colorfabb XT-CF?
Posted: Sat May 21, 2016 2:52 pm
Hi All,
I did some prints with the colorfabb XT-CF and recognized the very good stability/Stiffness.
Extreme High Flex Modulus (6.2 GPa) / twice as stiff as PLA
Moderate strain at break (8-10%), so no extreme brittle filament, but toughness
High Glass Temp. (Tg = 80C)
Very high Melt strength
Very high Melt Viscosity
Good dimensional accuracy and stability
Low odor / Styrene Free solution
Easy processing on many platforms
High attractive matt black surface
Prints came out very nice and due to I´m building a new Delta, I wonder if this material can be used for the effector Platform.
Anybody used this Material as a Efeector? I´m not shure due to the heat to use it for the Effector.
Would it be possible to use XT-CF for that design without going soft?
I did some prints with the colorfabb XT-CF and recognized the very good stability/Stiffness.
Extreme High Flex Modulus (6.2 GPa) / twice as stiff as PLA
Moderate strain at break (8-10%), so no extreme brittle filament, but toughness
High Glass Temp. (Tg = 80C)
Very high Melt strength
Very high Melt Viscosity
Good dimensional accuracy and stability
Low odor / Styrene Free solution
Easy processing on many platforms
High attractive matt black surface
Prints came out very nice and due to I´m building a new Delta, I wonder if this material can be used for the effector Platform.
Anybody used this Material as a Efeector? I´m not shure due to the heat to use it for the Effector.