Welcome to the SeeMeCNC Community

don't ask me how I got the color just right.

How did you get the colour just right?

I don't know, I just pressed the print button, and this Is what I got...

A quite unusual use for a Rostock. I would not have thought of doing that but congratulations for pulling it off!
Great Job!

was about halfway done when I took the pic. Here it is finished, the card is completely in cases in plastic, so good luck getting to the gift card inside.


should have made the shell only 1.5mm thick instead of 3mm though.

I would!

g.

Nice - That is awesome. Also - rad to see you are using MatterControl Sync. So useful.

Yeah, I like it.

We ended up using the tailgate of a pick-up truck to crack the thing open to get to the gift card.

I'm genuinely surprised we couldn't just snap it.

Sonrisa3D wrote:Nice - That is awesome. Also - rad to see you are using MatterControl Sync. So useful.

I have the first mattercontrol tablet. It's sitting on a shelf collecting dust. Couldn't get it to finish a print without rebooting in the middle somewhere.

had that problem once in about 50 prints.

I think you should take it back off the shelf and update the firmware.