Welcome to the SeeMeCNC Community

Posted: **Mon Jul 04, 2016 10:10 am**

I added and aluminum spreader to my bed, and so now it takes much longer to heat the bed. often times when i set the bed to 90c or more, it shuts off the heating before it even gets 75% there.

Where in the firmware can i extend this timer? I've been looking through the files in arduino but I haven found anything concrete and just want to make sure I'm adjusting the correct value. Thanks!!!

Posted: **Wed Jul 06, 2016 5:55 pm**

Bumping message, any firmware experts to answer this question?

Posted: **Wed Jul 06, 2016 11:36 pm**

No expert here

, but you can change it though the EEPROM.
Fourth value:

Max Inactive Time

Mine is set to 1800000 ms (30 minutes)

Welcome to the SeeMeCNC Community

Looking to extend the shut off timer past 20 minutes

Looking to extend the shut off timer past 20 minutes

Re: Looking to extend the shut off timer past 20 minutes

Re: Looking to extend the shut off timer past 20 minutes