Welcome to the SeeMeCNC Community

A warm greeting from Valdosta, Georgia. When I had two legs I was just over 7' tall and I was born in the UK.
I am interested in getting one or two Eris or just on Orion. I have 3 Flashforge Creator Pros and have 1 Wombot Exilis XL that is not liking Georgia humidity in anyway or form. So I print gau-8/a gatling gun pen holders, At this time mainly for the A-10 Pilots, Crew Chiefs and Ground Crews.

So I have a friend making my website and later I will have a Etsy store for the public.

I see SeeMeCNC uses MaterControl I will post in the Simplify3d section with a different question.

Welcome to the forum!
I can't help you on your decision to purchase 2 of the Eris or one of the Orion printers, that is strictly a choice to be made by you and your needs.
Whichever you decide to buy I hope that you will post pictures and participate in this forum. I just wanted to welcome you.