Welcome to the SeeMeCNC Community

Posted: **Mon Sep 26, 2016 2:27 pm**

I have taken a MAX V2 and upgraded the :

Extruder to the new one on the v3
the arms have been upgraded
the trucks now have the injection molded ones .
has the HE280 hotend .

couple questions i hope someone can answer .

in the configuration.h file when installing the new
firmware do we change the section :

#define PRINTER 2

or leave it unmodified ?

also with all these changes to the hardware are there any changes needed to the
Simplify 3d profile ?

Posted: **Tue Sep 27, 2016 7:08 am**

I found that I got more oozing with this nozzle that previously and I am still doing a little tweaking on my profile. I just upgraded mine to the new hotend over the weekend. What have you found on yours?

Posted: **Tue Sep 27, 2016 7:48 am**

lots of strings over open sections .

Posted: **Tue Sep 27, 2016 12:45 pm**

Excessive stringing can be caused by the retraction settings so I would experiment with different lengths and speeds to try to minimize the strings.

Welcome to the SeeMeCNC Community

HE280 Config and Setup on MAX v2 ?

HE280 Config and Setup on MAX v2 ?

Re: HE280 Config and Setup on MAX v2 ?

Re: HE280 Config and Setup on MAX v2 ?

Re: HE280 Config and Setup on MAX v2 ?