Welcome to the SeeMeCNC Community • Any chance for a .3mm Nozzle?

Page 1 of 1

Any chance for a .3mm Nozzle?

Posted: Fri Oct 21, 2016 3:19 pm

by ComJak

I realized that Seemecnc has down to .4mm nozzles but I was hoping to get a .3mm nozzle. Anyone know where I can snag one? Either in Brass or SS.

Re: Any chance for a .3mm Nozzle?

Posted: Fri Oct 21, 2016 3:39 pm

by mhackney

The E3D V6 nozzles fit, they stick out a little but that shouldn't be a problem.

Re: Any chance for a .3mm Nozzle?

Posted: Fri Oct 21, 2016 10:27 pm

by ComJak

mhackney wrote:The E3D V6 nozzles fit, they stick out a little but that shouldn't be a problem.

Awesome thanks,