SOC3D Here to break this new hotend...

[miaviator]

Greetings from Frigid Michigan.

We run a fabrication shop (3D printing, Molding and Casting, light metal fab, etc) with 7 active printers.

I'll be working on jamming this new hotend and pushing the V3 up to the 125-250mms print speeds using a .5 and .8mm nozzle should be fun.

[Xenocrates]

Very cool to see someone else in michigan (Yet again). Unfortunately, I'm on the other side of the state from you, or at least a 2 hour drive. Otherwise I'd be very tempted to come see your shop. Perhaps you could come up with a set of pictures of your shop area for us? It's always fun to see other peoples shops, especially when it's more than a few printers.