Page 1 of 1
Anyone switch to Matter Control 1.6?
Posted: Sun Nov 27, 2016 8:32 pm
by Burley
I did the update a couple of days ago, and am noticing a huge increase in print times. 1 hr 13 minutes to 2 hours 46 minutes. 176 layers became 351 layers. When I tried to revert to 1.5, I can no longer view the 2D layer screen....goes black and then.....silence and after a relaunch of MC, I don't dare to attempt to view the layer display or sync with it. Even after a complete uninstall of MC and a fresh install, it has the same screen behavior issue. Finally, I reinstalled 1.6, the layer view is now correct, but it is sloooow.
Jim
Re: Anyone switch to Matter Control 1.6?
Posted: Sun Nov 27, 2016 8:39 pm
by Mac The Knife
Matter control updates,,, Just when you got it all figured out, they come out with an update, and changes all the rules.
Re: Anyone switch to Matter Control 1.6?
Posted: Sun Nov 27, 2016 10:03 pm
by timskloss
We switched last week and I think it is a noticeable improvement in workflow versus 1.5. Now it is easier to modify presets. But the slicer is still slow for all but the simplest parts.
Re: Anyone switch to Matter Control 1.6?
Posted: Mon Nov 28, 2016 9:32 pm
by Outsider
I started using it the day it hit "ALPHA". I have 1.6.0.7828 and I like it over the previous version (1.5). Workflow is better and supports are better.