Welcome to the SeeMeCNC Community

Hi,

I guess this is more or less obvious, but I've only had my printer a few weeks and I want to make sure I do this right. It looks like I initially installed the firmware just a few days before the latest version came out.

Do I just follow the steps in "Step 5: Installing the Firmware" of the assembly guide? So I would clear the EEPROM and then download and install the latest version with the Arduino application?

Or is there something else?

Thanks!

That's exactly what you do. Following the same instructions will pull the latest firmware (new version just released today) and install it.

Cool. Thanks!