Welcome to the SeeMeCNC Community

Posted: **Fri Dec 16, 2016 10:36 am**

Hi guys,

When I change the speed settings in mattercontrol, the only one that seems to be different is non print moves. Sometimes when I bump things like the perimeter speeds up to 300mm/s or so the time estimation is longer, and the perimeters are certainly not printing at that speed. What's going on?

Posted: **Fri Dec 16, 2016 12:32 pm**

What are your cooling settings?

Posted: **Fri Dec 16, 2016 5:38 pm**

I'm wiling to bet your print speed is at odds with your minimum layer time setting.

g.

Posted: **Sat Dec 17, 2016 9:31 am**

Cooling is at 60% layer fans, unsure about the hotend fan. Where can I change the minimum layer time setting?

EDIT: Got it! I'll test it.

Welcome to the SeeMeCNC Community

Changing speed settings doesn't seem to make any difference?

Changing speed settings doesn't seem to make any difference?

Re: Changing speed settings doesn't seem to make any difference?

Re: Changing speed settings doesn't seem to make any difference?

Re: Changing speed settings doesn't seem to make any difference?