Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.

craftymethod · Post by **craftymethod** » Tue Jan 17, 2017 6:35 am

Was working fine previously!

Any ideas guys?

craftymethod · Post by **craftymethod** » Tue Jan 17, 2017 6:50 am

Im pretty sure I cleared EEPROM also.

Post by **geneb** » Tue Jan 17, 2017 8:55 am

Almost sounds like a power supply issue.

g.

craftymethod · Post by **craftymethod** » Wed Jan 18, 2017 1:20 am

I tried just setting up with Simplify3D, but it seems I need to install Mattercontrol so I can find my build volume and set Horizontal radius.

Screen scramble and power off issue only seems to be present when connecting to Matter control.

Welcome to the SeeMeCNC Community

Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.

Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.

Re: Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.

Re: Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.

Re: Rostock V2 setep on new computer, Screen often scrambled on connect, often power shutoff ~5 mins into print.