Setting up Cura with Octoprint

[WLJayne]

Hi guys,

So I've gone through all the procedures of setting up my V3 for wifi printing with octoprint and it's all fine, however now I'm trying to set up cura on my PC for faster slicing and gcode export. However when trying to add a new printer, there is no option for a circular bed as shown in the guide. It appears that in the current cura version deltas are not supported. Where do I go from here?

EDIT: I should have looked more before posting this. Tons of help at the top of the page. I am not a smart man.

[Mac The Knife]

Hi guys,

So I've gone through all the procedures of setting up my V3 for wifi printing with octoprint and it's all fine, however now I'm trying to set up cura on my PC for faster slicing and gcode export. However when trying to add a new printer, there is no option for a circular bed as shown in the guide. It appears that in the current cura version deltas are not supported. Where do I go from here?

The Cura thread?

[WLJayne]

I should have looked more closely. It doesn't matter much now anyway, I'm trying to ferret out mhackney's info on KISSlicer anyway, which appears to be the better choice.