Welcome to the SeeMeCNC Community

Not that anyone missed me, but I did just kind of vanish from the 3D printing world for a while (shut down my 3DHubs, stopped developing my V3DR printer, sold my FlashForge, and only printed when I actually needed something). That's all changed now and I'm back full force with a new full time job in a new city. Planning on finishing up/releasing my V3DR design (current picture shown below) and begin to fully develop a new high-end machine that has been rolling around in my brain for quite a while now.

Anyway, just wanted to say hello again and glad to see this forum is still up and running.

[img]https://c1.staticflickr.com/3/2493/3282 ... f6d5_c.jpg[/img]

Welcome back to the zoo! Nice looking printer you've built.

I'm still the same terrible person (apparently) that I was the last time you were here.

We lost Eaglezsoar to illness while you were gone, which /really/ sucks.

g.

Nice to see you back. I really liked the V3DR, and have been pointing it out to people and slowly plotting to print one for a print Lab at the college, so that people could see a Delta style machine instead of just Cartesians.

Wow, that really sucks to hear about Eaglezsoar.