New 3D printer user in Arizona

[BryanK]

Hello,
Brand new to 3D printing and of course I chose a Delta to dive into the deep end of the pool with lol. Purchased the Rostock Max v3 kit and it was a joy to assemble, but now am getting pretty heavy into the calibration woes / complexities to attempt higher quality prints. Look forward to browsing and talking with you all.

Bryan

[Dionysus480]

Welcome to the forum. I'm down in Mesa and have really enjoyed this endeavor as the forums are very helpful, and they are great at explaining the solution so you can identify similar problems and solve them as well.

One small thing is that we don't have to problems with filament moisture that some other areas have. Put the filament outside in sun for 30min and its pretty much back to dry as a bone.