Welcome to the SeeMeCNC Community

Hey Guys,

Not sure I'm even in the right forum for this question, but anyways here goes;

I just got done putting my Max V3 kit together and I bought a raspberry pi with the kit, and I see not info on what connections to make with the Raspberry Pi? The only connection it has right now is a wire whip between it and the Rambo board, to power the PI. What else needs to be hook up and where to? I could make some assumptions, but sometimes that turns out bad!

BTW, I bought the PI so I could communicate with the printer wireless. I can do all the software install, but i want to make sure I'm connecting it right!

Thanks for your help! Pics added

Take a look at steps 12-14 in the top section assembly guide.

g.

Thank you good sir! I don't even know how I passed those steps! I saw the step to place it, and then must have meant to back and hook it up, but moved forward.

Anyway, I got it!

\o/