Welcome to the SeeMeCNC Community

New owner of a v3 here, looking to get some help with an issue I am having currently.

As of recent I am unable to calibrate my machine correctly. I keep getting an -OFFSET OFF BY TOO MUCH TRYING AGAIN- at the end of the calibration, resulting in it retrying and having this happen in a loop.

Things I've done
check belt tension
swap out accelerometer board
square my towers up
clearing eeprom/reflash firmware

But to no avail. Any help would be appreciated

Maybe your endstop screws are too high or uneven, try screwing them all down so they are all the same level and try again. Are you using most current firmware? I think there was something buggy with the recent one so try the previous file.

Welp now I feel stupid..

screwing int he carriage endstop screws fixed the problem instantly haha..


Many thanks for the help.