Welcome to the SeeMeCNC Community

Posted: **Sun Feb 24, 2013 4:53 pm**

Dear all,

I try to connect the Rambo to my laptop but the system cannot find a new device (the led on the rambo is on/green, jumper set to external power source).

I've plug the USB cable, reboot, scan for new devices, ....

Do you have already see this type of behaviour (I'm running on windows 8 64 bits version)?

Thanks in advance,

Gwen

Posted: **Mon Feb 25, 2013 5:31 am**

Done a test today, and it's strange:

- jumper set to USB : no green led
- jumper set to USB : green led on when endstop X is unplugged!

And the second solution permit to have the device listed in the device Manager (W8 64 bits).

Strange, stange!

Posted: **Mon Feb 25, 2013 5:44 am**

found It, just inversion between the 2 wires of the X endstop!

Noob mistake, Argh!

Welcome to the SeeMeCNC Community

First try - but device not found in W8 64 bits

First try - but device not found in W8 64 bits

Re: First try - but device not found in W8 64 bits

Re: First try - but device not found in W8 64 bits