FSR Wire Routing
Posted: Tue May 30, 2017 10:27 pm
I am installing the FSR probing kit from Ultibots on my Rostock Max v3, following Michael Hackney's instructions on his blog (thank you Michael!).
The only issue I am running into is where to route the wires from the JohnSL board in the base to the Duet 3D board in the top. I thought maybe the tower extrusions, however there is no room. Suggestions?
Thank you!
The only issue I am running into is where to route the wires from the JohnSL board in the base to the Duet 3D board in the top. I thought maybe the tower extrusions, however there is no room. Suggestions?
Thank you!