Print head fan won't turn on during print (gcode issue?)

ared38 · Post by **ared38** » Tue Jun 20, 2017 4:22 pm

Hi folks,

When I adjust the print head fan speed using the console it works fine. But when I start printing something, the fans turn off.

I've attached the gcode. It has a line "M106 S255". When I use the mattercontrol terminal this command starts the fans, but it doesn't seem to when I print.

Any ideas? Does cura not play nice with rostock V3?

Post by **geneb** » Wed Jun 21, 2017 7:43 am

The layer fans will only run when layer cooling is active. The layer cooling is controlled by the slicer configuration.

g.

Welcome to the SeeMeCNC Community

Print head fan won't turn on during print (gcode issue?)

Print head fan won't turn on during print (gcode issue?)

Re: Print head fan won't turn on during print (gcode issue?)