Welcome to the SeeMeCNC Community

This is one of the first Orion's and it has been upgraded several times to keep up with the improvements seen in the current Orion. It calibrates well and prints fine I just have one too many 3D printers and this one doesn't get much use anymore. I will have safely packaged in an appropriately sized shipping box.

Asking Price is $600 USD plus the cost of whatever shipping method you choose (shipped within continental USA)

Upgrades Installed:
- HE280 Hotend with Accelerometer Probe
- Orion Delta Ball-Cup Delta Arm Kit
- Injection Molded Cheapskate Carriage Set
- Latest Firmware

Add On's Included:
- Extra Orion Glass Build Plate 220mm
- Extra EZStruder Cold End Kit
- Glue Stick

In the Box:
- Orion 3D Printer (as shown in photos)
- Spool Holder
- USB Cable (attached)
- Power Cable (attached)
- Binder Clips for Glass/Bed
- Extra Orion Glass Build Plate 220mm
- Extra EZStruder Cold End Kit
- Glue Stick

For shipping, you're better off inverting the arms. (Move the carriages all the way to the bottom, so that the hot end forms the apex of a pyramid.)

g.

So the hotend is floating above with no other support?

So the hotend cannot damage the bed or bash the nozzle against anything, and so that the carriages can be placed in a secure position and locked down somewhat, while keeping things away from the nozzle and thermistor

Reducing Price to $500 plus actual shipping costs

NO LONGER AVAILABLE

I couldn't sell it but did give it away to a co-worker.

Hopefully, six months from now, your coworker will still think of you as a friend .

Giving it away is way better then throwing it away.