New Enclosure for my V3
Posted: Sat Nov 18, 2017 3:40 pm
Printed the parts from this Thingiverse project:
https://www.thingiverse.com/thing:1796438
Used 6mm Luan subfloor for panels, 1 piece of Lexan for window in door. Total of about $40 including a can of white paint. Used garage door foam sealing tape around door. Aluminum duct tape on all interior panel seams. Maintains about 98 degrees F inside when printing ABS. Measured about 1" above print bed. Printer is in shop that is kept around 65 degrees.
https://www.thingiverse.com/make:405336
https://www.thingiverse.com/thing:1796438
Used 6mm Luan subfloor for panels, 1 piece of Lexan for window in door. Total of about $40 including a can of white paint. Used garage door foam sealing tape around door. Aluminum duct tape on all interior panel seams. Maintains about 98 degrees F inside when printing ABS. Measured about 1" above print bed. Printer is in shop that is kept around 65 degrees.
https://www.thingiverse.com/make:405336