Welcome to the SeeMeCNC Community

Hi all,

I hope that this is in the right section.

I have a SeeMeCNC Orion and two Ultimakers. I am wondering if anyone has created a separate profile for their Orion using Cura? I'd like to consolidate my operation to one slicing program, if possible. Has anyone used Cura with their Orion, and are you willing to share with me the specs?

Thanks,

Andrea

Oh, woah...

I think that I resolved my own problem: https://seemecnc.dozuki.com/Guide/Setti ... 87?lang=en

I'll set it up, and once I reassemble my printer, I'll give it a go.