Page 1 of 1
Wire Harness Connector Part Numbers? for Effector
Posted: Sat Mar 24, 2018 3:39 pm
by wepollock
I just wanted to stock a few extra male and female connectors for the effector wire harness.
What are the part numbers Molex or Mouser?
I would need both male and female; i think four pin and ten pin; and then a 2 pin jst?
Re: Wire Harness Connector Part Numbers? for Effector
Posted: Tue Mar 27, 2018 3:07 pm
by wepollock
Actually they may be TE connectors. 4 position and 10
I want to standardize on connectors. If you could shoot me a PM that is appreciated.
Re: Wire Harness Connector Part Numbers? for Effector
Posted: Wed Mar 28, 2018 7:57 am
by geneb
You're unlikely to get an answer to that here. Contact support directly.
g.
Re: Wire Harness Connector Part Numbers? for Effector
Posted: Thu Mar 29, 2018 9:43 pm
by adarcher
Feel free to share the information once you find out though.
I'm not a fan of the connectors and will probably make some conversions myself at some point.