Quick Clip connector

[Glacian22]

Hey all, I added a yellowjacket quickclip to my very modded RMax V1 a little while ago, in an effort to simplify my hotend wiring. If works well, but now the wire harness keeps coming loose, killing prints midway through. The wire harness feels like it clicks in securely, but I guess it isn't tight enough somehow? Considering adding a dab of hotglue, but that feels so counterproductive to have a quick disconnect. Any ideas?

[geneb]

A bit of masking tape would work too.

g.

[Glacian22]

True! I think I'm just going to bite the bullet and go with a line of hot glue...it shouldn't be too hard to pry off later on.