Very New, very green
Posted: Tue Jun 05, 2018 2:36 pm
Greetings all,
I have never owned or printed with any 3D printer before, though oddly enough I was involved in the design of FormLabs 1. I work with robotics fairly frequently and have been wanting a printer for quite some time so I can make some custom parts. After several months of research, reading reviews, reading here, and facebook posts, I finally purchased a Rostock Max 3.2.
My son and I built it together and took our time. I would say total build time was about 16+ hours. We ran into a couple glitches and frustrations, but worked through them. Yesterday the build was complete and I printed the little steam boat. Damn near flawless! Resolution was higher than I expected for a demo print. There was a little stringing, but that is trivial.
Now I have to print the Due case. Will start that tonight.
I have never owned or printed with any 3D printer before, though oddly enough I was involved in the design of FormLabs 1. I work with robotics fairly frequently and have been wanting a printer for quite some time so I can make some custom parts. After several months of research, reading reviews, reading here, and facebook posts, I finally purchased a Rostock Max 3.2.
My son and I built it together and took our time. I would say total build time was about 16+ hours. We ran into a couple glitches and frustrations, but worked through them. Yesterday the build was complete and I printed the little steam boat. Damn near flawless! Resolution was higher than I expected for a demo print. There was a little stringing, but that is trivial.
Now I have to print the Due case. Will start that tonight.