Welcome to the SeeMeCNC Community

Hello All,
Has anyone installed the Zesty Nimble in the RailcoreII 300ZL?
I made a lg Delta printer with E3D V6 and the Nimble and the results are very good.
I thought the light extruder weight and remote extruder stepped would be a good fit for the RailcoreII.

/quadcells

Give it a shot and let us know how you like it! Sounds like it could be awesome. Don't forget that if you haven't already purchased the parts, these awesome folks have roped Project R3D into offering a kit now!

Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org

Hello,
Yea I will ask the guys over at Zesty Nimble for their advice on the mount for it.
I already ordered most of the parts and I did see that they have kits now.
Thanks for the railcore forum site.
/quadcells

RanchRifle wrote: Also, I imagine most folks working on these outfits are going to be heading over to the new forum at forum.railcore.org

I registered over there but still not activated. Does it take a while?

I doubt it is automated. May have to wake him up?

The activation email was in my spam folder.