Welcome to the SeeMeCNC Community

So My son and I had to take a break away from his printer- Max V2

We have upgraded it to a Duet Wifi. Well, I was a dumb... and while trying to upgrade to a new firmware I deleted everything on the SD card.

I've been searching for a while now. I remember someone had posted a really good guide that included all the config files.

Can someone please point me to that guide again.

Thanks

Ok slowly finding my way around again. Found the RepRapFirmware Configuration Tool.

Can anyone link me to the entries used for a Max V2?

Still searching here, no luck so far. Sorry it's been almost 10 months and just cant find any of the old info I had and I feel like I'm starting over.

Thanks

Sorry about the delay. perhaps http://forum.seemecnc.com/viewtopic.php ... duet+setup ?

Otherwise, I have a config for my modded V2 (E3D w/ PT100 sensors, Bondtech extruder, FSRs, etc), that I could potentially clean up for you.

Thanks. Mr Hackney helped me out.