Page 1 of 1
Upgraded V2 automagic calibration question.
Posted: Tue Nov 06, 2018 7:58 am
by barry99705
Hey guys, I have one of those fancy pants boards on the hot end so it does the tappity-tap-tap auto calibration. When it's doing this, shouldn't the effector platform stay parallel to the bed?
Re: Upgraded V2 automagic calibration question.
Posted: Tue Nov 06, 2018 8:59 am
by geneb
Which one do you have, the HE280 or the SE300? (what controller is in the printer?)
The effector should always be parallel with the build plate.
g.
Re: Upgraded V2 automagic calibration question.
Posted: Tue Nov 06, 2018 10:20 am
by barry99705
The HE280. Controller is the standard Rambo, not sure which version. Now that I've watched it a few times, I think it's the flying extruder I added. Pulling too much on the hot end.
Re: Upgraded V2 automagic calibration question.
Posted: Tue Nov 06, 2018 5:13 pm
by barry99705
Nope, that wasn't it. Now when I hit calibrate, the board resets. Any ideas? Firmware is 92.2
Re: Upgraded V2 automagic calibration question.
Posted: Tue Nov 06, 2018 6:49 pm
by barry99705
Holy crap. SD card corrupted. Put a new on in, and it was formatted fat32, didn't realize that. Reformatted fat, calibration runs now. Effector platform still not running level at the tap points though.
[img]
https://lh3.googleusercontent.com/BhXTL ... 24-h768-no[/img]
Re: Upgraded V2 automagic calibration question.
Posted: Wed Nov 07, 2018 8:23 am
by geneb
The image doesn't show up.
g.