effector plate
-
gaexcalibur
- Printmaster!
- Posts: 46
- Joined: Sun Jun 15, 2014 2:04 pm
- Location: Port Orchard Washington
effector plate
i have a max 2 completely stock but i have a problem. I was starting to get worse and worse prints so i finally stopped and examined everything i could. the one thing i noticed is the effector plate moves 1/4" freely without moving the arms. i double checked and it is moving and sliding without moving the arms. any ideas what i need to do would be great.
-
Khayrisill
- Printmaster!
- Posts: 69
- Joined: Thu Aug 25, 2016 9:09 am
Re: effector plate
Hello,
Do you have the ball joint version ? Verifies that the screws that hold the barbells (white parts) have not become loose.
A picture to illustrate would be appreciated.
Do you have the ball joint version ? Verifies that the screws that hold the barbells (white parts) have not become loose.
A picture to illustrate would be appreciated.