Welcome to the SeeMeCNC Community

Posted: **Wed Mar 13, 2019 2:21 am**

I don't have a probe yet, so I'm doing the paper thing. I wanted to do FSRs, but I have the Tricklaser metal frame which is discontinued and I don't think I can get the adapters anymore, though maybe I can figure out a solution myself.

Anyway, I noticed that my print's first layer was inconsistent and not even getting squished at a few parts. So I did the mesh grid compensation (manually) and got a concerning heat map back.

And I'm not really sure where to go from here. Maybe I screwed something up when I used Repetier Config Tool?

Posted: **Fri Mar 15, 2019 8:27 pm**

Are you sure that your points are correct? that sharp edge downwards suggests there's something wrong with the Z-probe (or another inconsistent factor)

Posted: **Wed Apr 24, 2019 9:39 pm**

Yikes! I suspect the probe as well. I have to do my probing with my heaters off otherwise it randomly triggers.

Welcome to the SeeMeCNC Community

Trying to calibrate after a Duet swap into my Metal Max. My height map is screwy.

Trying to calibrate after a Duet swap into my Metal Max. My height map is screwy.

Re: Trying to calibrate after a Duet swap into my Metal Max. My height map is screwy.

Re: Trying to calibrate after a Duet swap into my Metal Max. My height map is screwy.