Welcome to the SeeMeCNC Community

Hello,

Figured I would introduce my self.

Name is Mike.

I have been working on some projects. You might recognize the handle from the ESP8266 basic project.

Currently I am going through the beginning parts of doing a 3d printing start up.

Been working on an automatic part ejector for 3d printers and just got a sweet brand new Rostock max V4 to play with.

Will probably be pocking around here. Mabe looking for some curaengine 15.04 slicer settings.
Talking about peoples experiences with water soluble filament.

If you've got a v4, you're MUCH better off using Cura 3 or 4.

g.

I am open to doing this but only if using the curaengine.

I am currently working on some thing that requires that the workflow be handled completely with the command line.

If you know any example of using the new curaengine via the command line and the json settings ini file that would be greatly appreciated.

I would contact the Cura folks - I'm sure they can help you.

g.