Hello From Everett, WA
Posted: Sat Sep 14, 2019 11:41 am
It took many years to get me to purchase a 3D printer as I didn't know if I would use it enough to justify the cost.
Friend convinced me just over a year ago to buy a SeeMeCNC. So, I bought the V3.2 Kit. It went nearly flawlessly.
One one bad power supply which was replaced quickly in warranty.
Not using it enough? Ha! I've used the shit out of it. In fact, I needed to print faster. So, I bought a V4. Not so flawlessly of a build as I had with the V3.2, but it was expected. It's nearly perfect after a few adjustments, reversing the plugs, correctly aligning some pins, and replacing the head fans. I'm happy to have 2 printers pumping out the filament.
Friend convinced me just over a year ago to buy a SeeMeCNC. So, I bought the V3.2 Kit. It went nearly flawlessly.
One one bad power supply which was replaced quickly in warranty.
Not using it enough? Ha! I've used the shit out of it. In fact, I needed to print faster. So, I bought a V4. Not so flawlessly of a build as I had with the V3.2, but it was expected. It's nearly perfect after a few adjustments, reversing the plugs, correctly aligning some pins, and replacing the head fans. I'm happy to have 2 printers pumping out the filament.