Welcome to the SeeMeCNC Community

Hi,

Is the actual 'coupler' part removable so it can be replaced? I don't mean the full assembly which requires the PTC tool, I mean just the coupler with the teeth from that assembly?

How can I remove this coupler? ( I want to try a different coupler as I keep getting pucking pucks )

Thank you.

If you're talking about the bit that's got the push fit teeth inside of it, then yes that whole thing can be removed - it's threaded. Just remove the bowden tube from the EZ Struder and unscrew the fitting. Replacements can be found here: https://www.seemecnc.com/collections/pa ... tc-fitting

g.