SE300 Heater Power Problem

[ROvermeyer]

I built a Max V3, which I upgraded to a V3.2. The SE300 had the hotend power problem where it overheated the power connector for the hotend heater. I installed the SE300 Power Connector Upgrade Kit to fix this problem. I am again having hotend power problems and I found that the new power connector on the circuit board is broken, see attached photo. I see that SEEMECNC no longer sells the upgrade kit. Does anyone know what the part number of the 2 pin Molex receptcale is?

Thanks

20201103_140419.jpg (272.69 KiB) Viewed 4255 times

[geneb]

Contact support, they can help you out with that.

g.

[ROvermeyer]

geneb,

I posted this here and contacted support, support has responded.

Thanks.

Bob O.