Welcome to the SeeMeCNC Community

[img]http://mhackney.zenfolio.com/img/s8/v81 ... 0378-4.jpg[/img]


just arrived today - SeeMeCNC ABS in 1.75mm. I have another order of PLA coming in too. I'll be well stocked with all the colors I could need

These are really nice colors, I'm looking forward to printing with them.

cheers,
Michael

NICE.....!!!!! I agree with Barnett, we need a NE get together with other RostockMax owners. Must be a decent amount from CT, MA, RI (maybe not so much from RI...hehe). Please share the results.....I know you will.......

I am currently printing with SeeMeCNC 1.75 Brown ABS.
Nice stuff. Prints really smooth at 230c
glass bed with hairspray at 80c sticks great.

~*Brian V

Brian, are you getting any warping off the bed with that setup? Hitting 80C with my Onyx takes a while, but I CAN do it.

g.

I'm running low, need another spool. I buy mine one color at a time

I can vouch for the seemecnc neon orange, dark blue and black ABS sticking to glass/hairspray over mhackney's aluminum plate on the onyx at 80C (thermistor reading), hot end at 232C. The thermocouple on the glass reports a bit lower.

Of course, if I don't squish it on there, then it doesn't stick. But I haven't had bad warping. I could probably make it warp by blowing a desk fan on long thin parts. But for example I printed the spool holder extension kit today & needed a razor to get it off the glass.

[img]http://mhackney.zenfolio.com/img/s9/v88 ... 9396-4.jpg[/img]

Got some really nice PLA colors yesterday. These are SeeMeCNC - except the natural, which is Rainbot3D.

I also got a great red, but it's on the printer right now