Page 1 of 1
Bridging extreme (?)
Posted: Tue Apr 02, 2013 3:07 pm
by aehM_Key
Hello!
I couldn't find a better forum..
http://reviews.cnet.com/8301-33809_7-57 ... tail-store -> first picture
Is this possible?
MK
Re: Bridging extreme (?)
Posted: Tue Apr 02, 2013 10:12 pm
by cambo3d
that article was publish 7 months ago..just sayin.
Re: Bridging extreme (?)
Posted: Wed Apr 03, 2013 1:53 am
by aehM_Key
And?
Re: Bridging extreme (?)
Posted: Wed Apr 03, 2013 8:14 pm
by jesse
Should the 3d printer just slow down to extremely slow to let the plastic strand cool as it moves over the gap? After about a half a centimeter the plastic is cool.
It seems like my printer tries to get across as fast as possible while extruding as much plastic as possible.