Page 1 of 1
Repetier Host Stopping with error
Posted: Tue Apr 02, 2013 7:36 pm
by DaGroundZero
I searched the forum, but I didn't find an answer to my problem. I saw that there was a bug with Repetier Host that is stopping prints.
Mine is stopping with Error:No line number with checksum, last line:4856
The print stops.
Anyone have a suggestion?
Thanks,
Shawn
Re: Repetier Host Stopping with error
Posted: Wed Apr 03, 2013 9:35 pm
by DaGroundZero
Well after a few days of web searches and some trial and error, it seems I have gotten Repetier Hosts working with my mac book pro. I tried changing baud rates, ping pong mode, turning off the 3d view, and etc.
It seems like the magic check box was the firmware sends okay after error and/or forcing the ASCII protocol. After making these changes I was able to run the print job for the hollow test cube. Before it would stop between line 1 and 79 every time. Now that it seems that I might have the software sorted out, I will put on my hotend and extruder and finish the build. I plan on printing in plastic tomorrow!
I hope this helps someone else, and if I find out anything else, I will update this post.
Wish me luck.