Welcome to the SeeMeCNC Community

My first venture into 3d printing is being assembled by me at the moment, a Rostock Max...

I am an integrations and solutions architect in the Information Technology field and have a real interest in both the delta robots and 3d printing separately and when I came across the delta 3d print models I was in. Can't wait to finish the assembly make my first prints and see just what I can make this marvel do.

have fun, and welcome.. read through current build logs to see recent changes in the design not covered in the manual. that way you dont shoot yourself in the foot later on.

100LL? Must be another pilot.

- dan