Is he like the owner of this forum? He says I can't use this forum if I don't know how to use it. Are new people not allowed on here? Is there deep knowledge of forums required here? I didn't read anything like that here on the Seemecnc forum user guide.
If I am not allowed on here then can the owner of the site tell me so and I will gladly give up this forum and delete my account.
Namaste
Who is aehM_Key and why does he feel he can harass folks
-
elqisqeyano
- Printmaster!
- Posts: 256
- Joined: Sat Mar 30, 2013 1:29 pm
- Location: Franklin County Ohio
Re: Who is aehM_Key and why does he feel he can harass folks
lol,, dont worry about him. he is just one of many personalities on this forum you'll get to encounter.
My rostock build log http://forum.seemecnc.com/viewtopic.php?f=42&t=1228
-
elqisqeyano
- Printmaster!
- Posts: 256
- Joined: Sat Mar 30, 2013 1:29 pm
- Location: Franklin County Ohio
Re: Who is aehM_Key and why does he feel he can harass folks
Oh ok, I just wanted to make sure I was following rules here and not breaking any regulations. Thankscambo3d wrote:lol,, dont worry about him. he is just one of many personalities on this forum you'll get to encounter.
Namaste.
-
elqisqeyano
- Printmaster!
- Posts: 256
- Joined: Sat Mar 30, 2013 1:29 pm
- Location: Franklin County Ohio
Re: Who is aehM_Key and why does he feel he can harass folks
Hey, Got the Rosctock Max printing pretty well with that Nylon 618. Lot's to do to get rid of it warping but I am learning it more and more each print.cambo3d wrote:lol,, dont worry about him. he is just one of many personalities on this forum you'll get to encounter.
